TQP-48 Firmware Version History: 3.0 Service Release 08/19/2015 - Fixes issues with Cobranet at 96K. - Fixes Limiter attenuation bus linking. - Supports Ashly's Dante BKII carrier board. 2.9 Service Release 11/19/2014 - Corrected CobraNet-related issues with channel routing. - Corrected notification of parameter changes to subscribers on network. 2.8 Service Release 9/25/2014 - Corrected problem during factory reset were device name, device group, channel names, and link group names were incorrect. 2.7 Service Release 9/16/2014 - Corrected FIR issues: - Source filename had extra characters appended. - Insertion of FIR block caused mute until FIR coefficients loaded. - Corrected clearing of FIR filter state when new filter loaded. - Corrected bug where too-large Ethernet frame could be generated. - Improved OPDANTE detection. - Corrected reversed DHCP client ID. - Save logic output pin states as part of preset. 2.6 Service Release, 8/29/2014 - Added Dante support. - Fixed left/right adjacent channel swap. DSPs now always synched at start of processing. 2.2 Service Release, 11/14/2013 - Fixed rare left/right adjacent channel swap issue at 96k. 2.1 Service Release, 10/19/2012 - Corrected issues with bulk preset load. - Fixed left/right adjacent channel swap issue. - Reduced master clock source change pop noise to a small click noise. - Fixed "DSP Error During Preset Download" when clicking a bulk preset load. 2.0 Initial Release, 9/10/2012