NE4400, NE4800, NE8800 Firmware Revision History:
------------------------------------------------

3.1 - Service Release 06/13/2016
    - Fixed detection of Ashly's Dante BKII carrier board.

3.0 - Service Release 08/19/2015
    - Fixes issues with Cobranet at 96K.
    - Fixes Limiter attenuation bus linking.
    - Supports Ashly's Dante BKII carrier board.

2.9 - Service Release 11/18/2014
    - Fixes Cobranet receiver channel splitting/routing issues.
    - Fixes Cobranet receiver and transmitter parameters not getting recalled from preset.

2.8 - Service Release 9/26/2014
    - Fixes Device Name text issue after factory reset.

2.7 - Service Release 9/16/2014
    - Corrected FIR issues:
      - Source filename had extra characters appended.
      - Insertion of FIR block caused mute until FIR coefficients loaded.
      - Corrected clearing of FIR filter state when new filter loaded.
    - Corrected bug where too-large Ethernet frame could be generated.
    - Improved OPDANTE detection.
    - Corrected reversed DHCP client ID.
    - Save logic output pin states as part of preset.

2.6 - Service Release 08/07/2014
    - Fixes Cobranet occasionally not getting detected.
    - Makes the mic inputs the default selected inputs when mic input options installed.

2.5 - Service Release 06/27/2014
    - Supports Dante.

2.4 - Feature Release 03/17/2014
    - Supports Dante.

2.3 - Service Release 01/28/2014
    - Fixed left/right adjacent channel swap at 96K. DSPs now synch at start of processing.
    - Ashly and Fulcrum development forks merged (Ashly neXX00's now support FIRs).

2.2 - Service Release 04/26/2013
    - Fixed rare left/right adjacent channel swap found on ne4400.

2.1 - Service Release 10/19/2012
    - Fixed bulk load bug that corrupted presets by truncating blocks that were being appended.
    - Fixed padding to 16-bit words with OPT_PAD when the number of bytes written to flash was odd.

2.0 - Service Release 10/9/2012
    - Fixed left/right adjacent channel swap issue.
    - Reduced master clock source change pop noise to a small click noise.
    - Fixed "DSP Error During Preset Download" when clicking a bulk preset load.	 

1.9 - Service Release 2/8/2012
    - Disable any unused transmitter and receiver channels in CobraNet bundles.
    - Corrected display "feedback" issue on WR-5 when doing preset recalls.
    - Resolved Feedback Suppressor (FBS) issues:
      - Used newer (from PEMA) logic for handling FBS filter insertion.
      - Fixed incorrect number of cycles reported for FBS (and ANC).
      - Fixed incorrect blocking of update messages from FBS.

1.8 - Service Release 6/17/10
    - Changed logic input preset recall to trigger on a high-to-low transition.

1.7 - Service Release 5/25/10
    - Updated DSP cycle counts for HPF/LPF blocks.
    - Flush update queue when starting bulk update.
    - Block FBS filter update messages during bulk updates.
    - Changed maximum remote level from 50 to get full 50dB range.
    - Fixed DSP feedback suppressor bypass/unbypass so filters remain when unbypassed.
    - Added DSP auto-resetting upon floating-point invalid or overflow exception.

1.6 - Service Release 3/19/10
    - Resolved "DSP not responding" or "DSP checksum error" when using feedback suppressor & graphic EQ. 
    - Reduced meter SPI traffic by only sending meter messages for functions plugged.
    - Added Host to DSP message buffer queue for more robust messaging.
    - Fixed maximum delay values (it used to artificially limit at 682ms).

1.5 - Service Release 3/3/10
    - Fixed issues with DSP Usage Calculation
    - Fixed missing pointer for temp preset
    - Fixed missing input channel protection in ducking mixer.

1.4 - Service Release 11/20/09 
    - Improved FBS response 
    - Added Auto Mixer
    - Added neWR5    

1.3 - Service Release 10/19/09
    - Fixed issues with Mic Pre cards at 96K
    - Fixed issue with PEQ going to +15dB

1.2 - Service Release  10/15/09
    - Fixed issues in DSP (not passing audio on 4x4 )
    - Fixed errors during chan/ Mixer disable

1.1 - Service Release 10/9/09
    - Fixed issues in DSP
    - Added ES Support
    - Fixed various pops and clicks
    - Added Ambient Noise Comp.

1.0 - Initial Release 4/9/09