CA-1.02 Class D Power Amplifier Architect & Engineering Specs The amplifier shall be a 2-channel configuration of Class D design housed in a 2RU metal chassis with a metal front, including handles on either side. The front panel shall be equipped with input levels knobs and LED indicators for Temp, Current, Input signal (-45dB) and Clip/Mute (one for each channel). There shall also be general LED indicators for Protect Mode and Disable (indicates front panel lock). There shall be a front panel Power button that can switch between Power On and Standby Modes with an LED backlight to indicate status (Solid-ON, Blinking-Standby). The front panel shall be perforated on either side to allow proper air intake for cooling and a single variable-speed fan shall be mounted behind the vent. The amplifier's rear panel shall be equipped with 3.5mm removeable Balanced Euroblock connectors for each input as well as an XLR/1/4" combo jack. There shall also be a removeable 3-pole 3.5mm Euroblock connector for DC level control per channel. There is also a standby port for remote control of standby functions. A push-buttom switch selects Normal or Bridging operation for each channel pair. A set of DIP switches per channel allow a selectable 80Hz HPF and clip limiter to be switched on or off and for selecting amp gain of 26dB, 32dB, 38dB or 1.4V per channel. There shall also be DIP switches for front panel lockout and standby port polarity (NO/NC). The speaker outputs shall be a 4-pole 7.62mm removeable Euroblock for each channel pair. The two positive poles are set to deliver bridged power when required. There shall be a locking IEC power connection and the unit shall be supplied with the region-appropriate power cable. The amplfier shall be capable of driving up to 1,000W @ 2/4 Ohms or 70V per channel and 500W @ 8 Ohms per channel. The amplfier can also deliver 2,000W at 8 Ohms or 100V when in Bridge Mode. The amplifier shall have a universal power supply capable of operating from 100-240VAC, 50/60Hz and will have a current consumption @ 1/8 rated output of 3A. The amplfier housing shall measure 19" x 3.5" x 14.84" with a net weight of 13lbs. The amplfier shall be called the Ashly CA-1.02